IMU with IMS 7 Handling subsystem

IMU with IMS 7 Handling subsystem

 

On the Mechatronic Unit there is a workpiece carrier, with mounted and tested workpiece. A handling station is located above the center of the conveyor. The workpiece carrier is stopped at the removal position. The handling device lifts the workpiece and transports it to a deposit position. The empty workpiece carrier moves to the end of the conveyor belt, where it is taken over by the next unit.

Weboffer

 0 Article
Equipment set / product

Equipment set comprising the following:
1
Industrial Mechatronic Unit
 Industrial Mechatronic Unit LM9536
1
Handling station
 Handling station LM9683
1
Symmetrical workpiece transport pallet
 Symmetrical workpiece transport pallet LM9532
1
Workpiece, bottom section, white
 Workpiece, bottom section, white LM9524
1
Workpiece, bottom section, black
 Workpiece, bottom section, black LM9525
Accessories:
1
25-pin serial interface cable, Sub-D plug/socket
25-pin serial interface cable, Sub-D plug/socket LM9061
Media:
1
Interactive Lab Assistant: IMU 1 Industrial Mechatronic Unit
 Interactive Lab Assistant: IMU 1 Industrial Mechatronic Unit SO2805-5J
1
Interactive Lab Assistant: IMS X Mechatronic Basic Stations
 Interactive Lab Assistant: IMS X Mechatronic Basic Stations SO2805-5X
1
QuickChart IMU Industrial Mechatronic Unit
 QuickChart IMU Industrial Mechatronic Unit SO6200-2U
1
QuickChart IMS 7 Mechatronics Handling station
 QuickChart IMS 7 Mechatronics Handling station SO6200-1G
Additionally recommended:
1
Compressor, low-noise
Compressor, low-noise SE2902-9L
1
Tubing and accessory set for mechatronics systems
 Tubing and accessory set for mechatronics systems LM9571
1
Set of Allen keys
 Set of Allen keys LM9716

In areas where there are high levels of humidity the membrane dryer

with water trap should be used to avoid...   more

1
IDG3 membrane dryer with rapid coupling and filter AF20 with water trap
IDG3 membrane dryer with rapid coupling and filter AF20 with water trap LM9671