Lucas Nülle - IMS 8 Storage

IMS 8 Storage

IMS 8 Storage

A carrier with a fully assembled and tested workpiece is located on the conveyor belt. The carrier is stopped at the removal position. The handling module lifts up the workpiece and transfers it to one of twenty possible storage positions. The storage positions can be chosen according to the production task and test results. The empty carrier is conveyed to the end of the belt to be passed on to the next sub-system.

Training contents:

Assembly, set-up and testing of pneumatic cylinders and valves
Introduction to sub-systems for workpiece substructures
Defining processes for sorting
Programming of production sequences in manual and automatic modes

Weboffer

0 Article

Real Experience Learning

Interactive learning environment

Downloads

Equipment
Specifications

Tender specifications

Equipment set comprising the following:
1	Cyber physical conveyor system with PLC	LM9515
1	High rack storage station with 20 storage cells	LM9641
1	Touch Panel KTP700 Basic Trainer Package	CO3713-4Q
1	IMS displacement measurement module	LM9677
1	Symmetrical workpiece transport pallet	LM9532
5	Workpiece, top section, white	LM9521
5	Workpiece, top section, black	LM9522
5	Workpiece, bottom section, white	LM9524
5	Workpiece, bottom section, black	LM9525

Media:
1	Interactive Lab Assistant: IMS 1 Cyber Physical Conveyor Belt System	SO2805-5H
1	Interactive Lab Assistant: IMS 8 High Rack Storage	SO2805-5L
1	QuickChart IMS 1.5 Cyber-physical conveyor belt system	SO6200-2P
1	QuickChart, IMS 8 Mechatronics Storage sub-system	SO6200-1H

Accessories:
1	SybaPro experiment trolley, 3-level, 6 sockets, 1250x1970x800mm	ST7200-7A
1	DC power supply 24 V/5 A for IMS conveyor belts	LM9672
1	25-pin serial interface cable, Sub-D plug/socket	LM9061
1	Safety measurement cable 4mm, 100cm/40", blue, 600V CAT III ~1000V CAT II / 32A	SO5126-9A
1	Safety measurement cable 4mm, 100cm/40", red, 600 V CAT III ~1000 V, CAT II / 32A	SO5126-8U

Additionally recommended:
1		Compressor, low-noise	SE2902-9L
1		Tubing and accessory set for mechatronics systems	LM9571
1		Monitor holder for flat screen monitor of weight up to 15kg/33lbs	ST8010-4T
1		Protection cover for three-level experiment trolleys	ST7200-5L
1		Set of Allen keys	LM9716
	In areas where there are high levels of humidity the membrane dryer with water trap should be used to avoid... more In areas where there are high levels of humidity the membrane dryer with water trap should be used to avoid condensation: less
1		IDG3 membrane dryer with rapid coupling and filter AF20 with water trap	LM9671