IMS 5 Processing 

IMS 5 Processing 

 

A workpiece carrier is located on the conveyor belt. It is loaded with a fully assembled two-component workpiece (top and bottom pieces). The carrier and its load are positioned beneath the process module. The workpiece is clamped for processing. A bolt from the gravity-feed magazine is pressed into the hole in the workpiece. The clamp opens and the carrier and load are conveyed to the end of the belt to be passed on to the next sub-system.

Training contents:

  • Assembly, set-up and testing of pneumatic cylinders and valves
  • Introduction to sub-systems for workpiece substructures
  • Defining processes for sorting
  • Programming of production sequences in manual and automatic modes
Equipment set comprising the following:
1
Cyber physical conveyor system with PLC
Cyber physical conveyor system with PLC LM9515
1
Processing station
Processing station LM9682
1
IMS displacement measurement module
IMS displacement measurement module LM9677
1
Symmetrical workpiece transport pallet
Symmetrical workpiece transport pallet LM9532
1
Workpiece, top section, white
Workpiece, top section, white LM9521
1
Workpiece, bottom section, black
Workpiece, bottom section, black LM9525
3
Bolt workpiece, metal
Bolt workpiece, metal LM9527
3
Bolt workpiece, plastic red
Bolt workpiece, plastic red LM9528
Accessories:
1
DC power supply 24 V/5 A for IMS conveyor belts
DC power supply 24 V/5 A for IMS conveyor belts LM9672
1
Interface cable 25-pin, Sub-D socket / plug 1m
Interface cable 25-pin, Sub-D socket / plug 1m LM9066
Media:
1
Interactive Lab Assistant: IMS 1 Cyber Physical Conveyor Belt System
Interactive Lab Assistant: IMS 1 Cyber Physical Conveyor Belt System SO2805-5H
1
Interactive Lab Assistant: IMS X Mechatronic Basic Stations
Interactive Lab Assistant: IMS X Mechatronic Basic Stations SO2805-5X
1
QuickChart IMS 1.5 Cyber-physical conveyor belt system
QuickChart IMS 1.5 Cyber-physical conveyor belt system SO6200-2P
1
QuickChart, IMS 5 Mechatronics Process sub-system
QuickChart, IMS 5 Mechatronics Process sub-system SO6200-1E
Additionally recommended:
1
Compressor, low-noise
Compressor, low-noise SE2902-9L
1
Tubing and accessory set for mechatronics systems
Tubing and accessory set for mechatronics systems LM9571
1
Set of Allen keys
Set of Allen keys LM9716
1
Mechatronics experiment trolley with 2 level frame 1200x760x900mm WxHxDxD
Mechatronics experiment trolley with 2 level frame 1200x760x900mm WxHxDxD ST7200-3T
1
Monitor holder for flat screen monitor of weight up to (10kg / 22lbs)
Monitor holder for flat screen monitor of weight up to (10kg / 22lbs) ST8010-4K
1
Protective cover for 1200mm wide IMS experiment trolleys with training panel
Protective cover for 1200mm wide IMS experiment trolleys with training panel ST8010-8L

In areas where there are high levels of humidity the membrane dryer

with water trap should be used to avoid...   more

1
IDG3 membrane dryer with rapid coupling and filter AF20 with water trap
IDG3 membrane dryer with rapid coupling and filter AF20 with water trap LM9671
Optional Accessories:
1
Touch Panel KTP700 Basic Trainer Package
Touch Panel KTP700 Basic Trainer Package CO3713-4Q
1
IMS manual control unit
IMS manual control unit LM9638