“Schuko”-type measurement adapter with 4 mm-safety measuring sockets

Measurement adapter (for testing purposes only) for measuring current and voltage on 230 V conductors

This adapter makes it easy to measure AC voltage and current in appliances by plugging them directly into it. The adapter is simply connected between the appliance and the socket. Current in the live conductor “L” and the neutral conductor "N" can be measured individually without making any contact and it is also possible to measure leakage current in the protective earth conductor "PE". The insulated measurement rods are suitable for an AC current clamp. In addition, there are safety sockets available for taking direct measurements on the individual conductors.

• CEE 7/4 earth-contact plug system
• For current and voltage measurement
• Fitting for measurement via current probe
• Every conductor can be accessed individually
• Simultaneous measurement for power analysis
• Covered 4-mm safety sockets

Technical data

• Rod diameter: 14 mm approx.
• Opening for current probe: 30 mm x 30 mm
• Protected against water spray (IP44)
• Connector A: Earth contact with rubber pin
• Connector B: Earth contact with rubber coupling
• Nominal voltage 250 V/AC, nominal current 16 A
• Measurement category: CAT III
• Length 0.75 m