KNX-DALI Gateway, DALI2 Standard

The KNX/DALI gateway is used to control DALI devices via the KNX bus and is equipped with an integrated power supply.

The training board is used for training and must be equipped with 2 and 4mm sockets and additional connection terminals. Sockets and terminals must be labelled and lines must be depicted.

Function:

• 1 DALI output for up to 64 DALI devices
• DALI power supply is integrated
• DALI2 standard
• Control of 64 individual DALI devices, 16 groups, 16 scenes or in broadcast - 4 independent sequences
• With DT8 devices, Dim2Warm, HCL, set and dimming of colour temperature are possible
• Slave, stairway, forced, block and scene function are integrated, feedback is transmitted
• Another function is the standby deactivation in combination with a KNX switching actuator (e.g. SA/S)
• With ETS application version 2.0 and higher, the colour functions RGB(W) and HSV(W) can be used. This enables users to control, dim and adjust the colour of a lamp.
• Along with scenes, it is possible to parametrise 4 sequences per DALI output.
• The DALI gateways can also be integrated into a load control system.
• The DALI gateways measure the operating hours.

All of these functions can be used for individual ballasts and DALI groups. To diagnose and individually modify the DALI address or group assignment, a separate software tool is available (ABB i-bus® Tool).

Technical data:

• Output: 1 DALI
• output for up to 64 DALI devices
• Operating voltage:
  • 100-240 V AC/DC, 50/60 Hz
  • DALI output up to 230 V voltage proof (self-protection)
  • DALI voltage 16 V DC
  • DALI current max. 250 mA short-circuit proof
• Maximum power dissipation for device 2.0 W
• Inputs/outputs: 2 / 4 mm safety sockets
• Dimensions: 294 x 114 x 60 mm
• Weight: approx. 0.8 kg