Metalworking tool set 3, punch tools (22 tools), inlay size 300 x 600 mm

Tool inlays for drawers: Metalworking 3 – punch tools, set comprising 22 tools in two-tone (black/grey) foam inlay of dimensions 300x600mm,
suitable for drawers with a panel height of at least 100mm.

8 Drift punches:

• Fully hardened and annealed
• Inductively annealed head
• Ground and oiled working surface
• Chromium-molybdenum-vanadium 45CrMoV7/1.2328
• Manufactured in compliance with DIN 6458

11 Pin punches:

• Fully hardened and annealed
• Inductively annealed head
• Ground and oiled working surface
• Chromium-vanadium 59CrV4/1.2242
• Manufactured in compliance with DIN 6450

3 Hammers:
Plastic ball hammer

• Head held in place with cast zinc
• Interchangeable heads made of impact-resistant cellulose acetate
• Real ash handle, DIN 53505, Shore D 65

Recoilless nylon soft-face hammer

• Particularly suitable for hammering into positions
• For non-rebounding dead blows without any loss of hammer force but non-harmful to impacted materials
• Tough steel centre bar with stud and collar for attachment of heads
• Weight precisely determined by means of steel shot inside (inertial principle)
• Nylon heads, interchangeable
• Hickory handle, DIN 53505, Shore D 73

Rubber hammer

• With 2 flat striking faces
• Real ash handle, interchangeable heads
• DIN 5128-90, Shore A 90