Item No.: ST8003-6D

Double punched hole wiring installation cabin, 2 sides each 200x120x60 cm (HxWxD)

The double wiring installation cabin is designed for the assembly of electrical wiring installation circuits using standard, commercially-available components or boxes. The design and dimensions have been selected so that two trainees can work (from both sides) with no risk of injury, even if the task is of some complexity (ceiling installation, corner installation etc.) The components are fastened to the punched hole panels either by means of plastic plugs or a specially developed set of fasteners. Assembly materials for floor, walls or joining components are included. 

Technical data:

  • 4 Side sections 1.2x1.0m with punched hole grid for attachment of components
  • 4 Rear wall sections 1.2x1.0m with punched hole grid for attachment of components
  • 1 Cover section 1.2x1.0m with punched hole grid for attachment of components
  • Set of assembly materials
  • Punched hole grid 5x10mm
  • Dimensions:  1.2x2.0x1.2m (w x h x d)

Punched-hole frame, interchangeable, to hang in existing panel-mounting frames

  • 5x10mm perforation for quick and safe attachment of standard installation materials (using plastic plugs) and mounting the Experiment Boxes system
  • Surface powder-coated using RAL7047
  • Dimensions: 1120x695mm (w x h)