-
Diodes in DC and AC circuits
-
Half-wave and bridge rectifiers with smoothing
-
Displaying diode characteristics on an oscilloscope
-
Light-emitting diodes
-
Photodiodes
-
Diode-like characteristics of transistor circuits
-
Input, output and control characteristics of transistors
-
Transistors in common emitter, common collector and common base circuits
-
Transistors used as switches
-
Transistors used as delay switches
-
Characteristics of field effect transistors (FETs)
-
FETs used as controllable resistors and switches
-
MOSFET characteristic
-
Dimmer sensor using a MOSFET
-
Characteristics of diacs, thyristors and triacs
-
Thyristors used as switches
-
Phase control using triacs and diacs
-
Basic amplifier circuits using bipolar transistors
-
Basic amplifier circuits using field effect transistors (FETs)
-
Two-stage AC amplifier
-
Darlington pair amplifier
-
Coupled emitter amplifiers
-
Phase reversing stages
-
Differential amplifiers
-
Two-stage DC amplifier with complementary transistors
-
Push-pull amplifiers
-
Positive and negative feedback
-
Square-wave generators
-
Threshold switches (Schmitt triggers)
-
Astable multivibrators
-
Monostable multivibrators
-
Bistable multivibrators (flip-flops)
-
Saw tooth generators (pulse generators)
-
Sine-wave generators with RC and LC elements
-
Amplitude modulators and demodulators
-
Frequency modulator
-
Single-phase and three-phase rectifier circuits
-
Voltage multipliers
-
Stabilising circuits
-
Voltage and current regulators (linear)
-
Switched-mode voltage regulators
-
DC converters
-
Pulse generation using diacs
-
Pulse generation using unijunction transistors
-
Phase control using thyristors
-
Phase control using triacs
-
Full-wave control with zero-voltage switch
-
DC voltage switch using thyristors
-
Using op amps as inverting amplifiers
-
Using op amps as non-inverting amplifiers
-
Using op amps as differential amplifiers
-
Dynamic response of operational amplifiers (op amps)
-
1 x switch, 1 x push-button, 1 x relay (15 V)
-
1 x light bulb, 15V with E10 socket
-
Resistors: 1 x 10 ohm, 2 x 22 ohm, 1 x 33 ohm, 2 x 100 ohm, 1 x 220 ohm, 1 x 330 ohm, 1 x 470 ohm, 1 x 680 ohm, 3 x 1k ohm, 2 x 2.2k ohm, 3 x 4.7k ohm, 3 x 10k ohm, 3 x 22k ohm, 2 x 47k ohm, 2 x 100k ohm, 1 x 1M ohm
-
1 x potentiometer 100 ohm, 1 x potentiometer 1k ohm, 1 x potentiometer 10k ohm
-
1 x NTC, 1 x PTC, 1 x VDR, 1 x LDR
-
Capacitors: 1 x 10nF, 1 x 47nF, 2 x 0.1µF, 1 x 0.22µF, 2 x 0.47µF, 2 x 1µF
-
Electrolytic capacitors: 2 x 10µF, 1 x 100µF, 1 x 470µF
-
coils: 1 x 10mH, 1 x 33mH
-
1 x coil n=300, 2 x coil n=900, 1 set of cut strip-band core
-
1 x LED red, 2x LED green
-
6 x diodes, 1N4007, 1 x germanium diode (AA118)
-
1 x Zener diode 4.7V
-
1 x transistor, BC547, base left, 1 x transistor, BC547, base right
-
1 x transistor, BD237, base left, 1 x transistor, BD237, base right
-
1 x transistor, BD238, base right
-
1 x field-effect transistor J112, 1 x MOSFET BS170
-
1 x diac DB3, 1 x triac MAC97A6, 1 x thyristor MCR100-6
-
1 x unijunction transistor
-
1 x op-amp TL071C
-
1 x speaker 0.25w
-
Storage board, DIN, WxHxD 456 x 297 x 100 mm
-
Depth with plug-components 150mm