CAN fault simulator

The CAN fault simulator can be integrated into any CAN-bus data line. The actual fault circuit is located inside a lockable lid where eight switches are used to enable the standard ISO faults.

The following faults can be activated:

• Break CAN-Low

• Break CAN-High

• Fault to battery positive CAN-Low

• Fault to earth CAN-High

• Fault to earth Can-Low

• Fault to battery positive CAN-High

• Fault CAN-High to CAN-Low

• 500 Ohm resistance in CAN-High line

Panel description

• Compatible to Low-Speed and High-Speed CAN-bus (ISO 11898-2 and ISO 11898-3)

• Operating voltage 12V/13.8V

• Inputs: 2 mm measurement sockets and 4-mm safety sockets

• Outputs: 2 mm measurement sockets and 4-mm safety sockets

• Vehicle-specific terminal designation

• Continuous power supply via terminal 30 and 15 in the upper region

• Continuous ground via terminal 31 in the lower region

• Coloured screen printing

• Dimension: 297 x 114 x 60mm

• Weight 1.0 kg